pmsignal(1) — Linux manual page

NAME | SYNOPSIS | DESCRIPTION | OPTIONS | PCP ENVIRONMENT | SEE ALSO | COLOPHON

PMSIGNAL(1)              General Commands Manual             PMSIGNAL(1)

NAME         top

       pmsignal - send a signal to one or more processes

SYNOPSIS         top

       $PCP_BINADM_DIR/pmsignal [-alnp] [-s signal] [PID ...|name ...]

DESCRIPTION         top

       pmsignal provides a cross-platform event signalling mechanism for
       use with tools from the Performance Co-Pilot toolkit.  It can be
       used to send a named signal (only HUP, USR1, TERM, and KILL are
       accepted) to one or more processes.

       The processes are specified directly using PIDs or as program
       names (with either the -a or -p options).  In the all case, the
       set of all running processes is searched for a basename(1) match
       on name.  In the program case, process identifiers are extracted
       from files in the $PCP_RUN_DIR directory where file names are
       matched on name.pid.

       The -n option reports the list of process identifiers that would
       have been signalled, but no signals are actually sent.

       If a signal is not specified, then the TERM signal will be sent.
       The list of supported signals is reported when using the -l
       option.

       On Linux and UNIX platforms, pmsignal is a simple wrapper around
       the kill(1) command.  On Windows, the is no direct equivalent to
       this mechanism, and so an alternate mechanism has been
       implemented - this is only honoured by PCP tools, however, not
       all Windows utilities.

OPTIONS         top

       The available command line options are:

       -a, --all
            Send signal to all named processes.

       -l, --list
            List supported signals.

       -n, --dry-run
            List processes that would be affected.

       -p, --program
            Extract programs from PCP runtime PID files.

       -s signal, --signal=signal
            Specify the signal to send, one of: HUP, USR1, TERM, KILL.

       -?, --help
            Display usage message and exit.

PCP ENVIRONMENT         top

       Environment variables with the prefix PCP_ are used to
       parameterize the file and directory names used by PCP.  On each
       installation, the file /etc/pcp.conf contains the local values
       for these variables.  The $PCP_CONF variable may be used to
       specify an alternative configuration file, as described in
       pcp.conf(5).

SEE ALSO         top

       basename(1), kill(1), killall(1), pcp.conf(5) and pcp.env(5).

COLOPHON         top

       This page is part of the PCP (Performance Co-Pilot) project.
       Information about the project can be found at 
       ⟨http://www.pcp.io/⟩.  If you have a bug report for this manual
       page, send it to [email protected].  This page was obtained from the
       project's upstream Git repository
       ⟨https://github.com/performancecopilot/pcp.git⟩ on 2024-06-14.
       (At that time, the date of the most recent commit that was found
       in the repository was 2024-06-14.)  If you discover any rendering
       problems in this HTML version of the page, or you believe there
       is a better or more up-to-date source for the page, or you have
       corrections or improvements to the information in this COLOPHON
       (which is not part of the original manual page), send a mail to
       [email protected]

Performance Co-Pilot               PCP                       PMSIGNAL(1)

Pages that refer to this page: pmcd(1)