subpage_prot(2) — Linux manual page

NAME | LIBRARY | SYNOPSIS | DESCRIPTION | RETURN VALUE | ERRORS | STANDARDS | HISTORY | NOTES | SEE ALSO | COLOPHON

subpage_prot(2)            System Calls Manual           subpage_prot(2)

NAME         top

       subpage_prot - define a subpage protection for an address range

LIBRARY         top

       Standard C library (libc, -lc)

SYNOPSIS         top

       #include <sys/syscall.h>      /* Definition of SYS_* constants */
       #include <unistd.h>

       int syscall(SYS_subpage_prot, unsigned long addr, unsigned long len,
                   uint32_t *map);

       Note: glibc provides no wrapper for subpage_prot(), necessitating
       the use of syscall(2).

DESCRIPTION         top

       The PowerPC-specific subpage_prot() system call provides the
       facility to control the access permissions on individual 4 kB
       subpages on systems configured with a page size of 64 kB.

       The protection map is applied to the memory pages in the region
       starting at addr and continuing for len bytes.  Both of these
       arguments must be aligned to a 64-kB boundary.

       The protection map is specified in the buffer pointed to by map.
       The map has 2 bits per 4 kB subpage; thus each 32-bit word
       specifies the protections of 16 4 kB subpages inside a 64 kB page
       (so, the number of 32-bit words pointed to by map should equate
       to the number of 64-kB pages specified by len).  Each 2-bit field
       in the protection map is either 0 to allow any access, 1 to
       prevent writes, or 2 or 3 to prevent all accesses.

RETURN VALUE         top

       On success, subpage_prot() returns 0.  Otherwise, one of the
       error codes specified below is returned.

ERRORS         top

       EFAULT The buffer referred to by map is not accessible.

       EINVAL The addr or len arguments are incorrect.  Both of these
              arguments must be aligned to a multiple of the system page
              size, and they must not refer to a region outside of the
              address space of the process or to a region that consists
              of huge pages.

       ENOMEM Out of memory.

STANDARDS         top

       Linux.

HISTORY         top

       Linux 2.6.25 (PowerPC).

       The system call is provided only if the kernel is configured with
       CONFIG_PPC_64K_PAGES.

NOTES         top

       Normal page protections (at the 64-kB page level) also apply; the
       subpage protection mechanism is an additional constraint, so
       putting 0 in a 2-bit field won't allow writes to a page that is
       otherwise write-protected.

   Rationale
       This system call is provided to assist writing emulators that
       operate using 64-kB pages on PowerPC systems.  When emulating
       systems such as x86, which uses a smaller page size, the emulator
       can no longer use the memory-management unit (MMU) and normal
       system calls for controlling page protections.  (The emulator
       could emulate the MMU by checking and possibly remapping the
       address for each memory access in software, but that is slow.)
       The idea is that the emulator supplies an array of protection
       masks to apply to a specified range of virtual addresses.  These
       masks are applied at the level where hardware page-table entries
       (PTEs) are inserted into the hardware page table based on the
       Linux PTEs, so the Linux PTEs are not affected.  Implicit in this
       is that the regions of the address space that are protected are
       switched to use 4-kB hardware pages rather than 64-kB hardware
       pages (on machines with hardware 64-kB page support).

SEE ALSO         top

       mprotect(2), syscall(2)

       Documentation/admin-guide/mm/hugetlbpage.rst in the Linux kernel
       source tree

COLOPHON         top

       This page is part of the man-pages (Linux kernel and C library
       user-space interface documentation) project.  Information about
       the project can be found at 
       ⟨https://www.kernel.org/doc/man-pages/⟩.  If you have a bug report
       for this manual page, see
       ⟨https://git.kernel.org/pub/scm/docs/man-pages/man-pages.git/tree/CONTRIBUTING⟩.
       This page was obtained from the tarball man-pages-6.9.1.tar.gz
       fetched from
       ⟨https://mirrors.edge.kernel.org/pub/linux/docs/man-pages/⟩ on
       2024-06-26.  If you discover any rendering problems in this HTML
       version of the page, or you believe there is a better or more up-
       to-date source for the page, or you have corrections or
       improvements to the information in this COLOPHON (which is not
       part of the original manual page), send a mail to
       [email protected]

Linux man-pages 6.9.1          2024-05-02                subpage_prot(2)

Pages that refer to this page: syscalls(2)