tc-nat(8) — Linux manual page

NAME | SYNOPSIS | DESCRIPTION | OPTIONS | NOTES | SEE ALSO | COLOPHON

NAT action in tc(8)               Linux              NAT action in tc(8)

NAME         top

       nat - stateless native address translation action

SYNOPSIS         top

       tc ... action nat DIRECTION OLD NEW

       DIRECTION := { ingress | egress }

       OLD := IPV4_ADDR_SPEC

       NEW := IPV4_ADDR_SPEC

       IPV4_ADDR_SPEC := { default | any | all |
               in_addr[/{prefix|netmask}]

DESCRIPTION         top

       The nat action allows one to perform NAT without the overhead of
       conntrack, which is desirable if the number of flows or addresses
       to perform NAT on is large. This action is best used in
       combination with the u32 filter to allow for efficient lookups of
       a large number of stateless NAT rules in constant time.

OPTIONS         top

       ingress
              Translate destination addresses, i.e. perform DNAT.

       egress Translate source addresses, i.e. perform SNAT.

       OLD    Specifies addresses which should be translated.

       NEW    Specifies addresses which OLD should be translated into.

NOTES         top

       The accepted address format in OLD and NEW is quite flexible. It
       may either consist of one of the keywords default, any or all,
       representing the all-zero IP address or a combination of IP
       address and netmask or prefix length separated by a slash (/)
       sign. In any case, the mask (or prefix length) value of OLD is
       used for NEW as well so that a one-to-one mapping of addresses is
       assured.

       Address translation is done using a combination of binary
       operations. First, the original (source or destination) address
       is matched against the value of OLD.  If the original address
       fits, the new address is created by taking the leading bits from
       NEW (defined by the netmask of OLD) and taking the remaining bits
       from the original address.

       There is rudimental support for upper layer protocols, namely
       TCP, UDP and ICMP.  While for the first two only checksum
       recalculation is performed, the action also takes care of
       embedded IP headers in ICMP packets by translating the respective
       address therein, too.

SEE ALSO         top

       tc(8)

COLOPHON         top

       This page is part of the iproute2 (utilities for controlling
       TCP/IP networking and traffic) project.  Information about the
       project can be found at 
       ⟨http://www.linuxfoundation.org/collaborate/workgroups/networking/iproute2⟩.
       If you have a bug report for this manual page, send it to
       [email protected], [email protected].  This page was
       obtained from the project's upstream Git repository
       ⟨https://git.kernel.org/pub/scm/network/iproute2/iproute2.git⟩ on
       2024-06-14.  (At that time, the date of the most recent commit
       that was found in the repository was 2024-06-11.)  If you
       discover any rendering problems in this HTML version of the page,
       or you believe there is a better or more up-to-date source for
       the page, or you have corrections or improvements to the
       information in this COLOPHON (which is not part of the original
       manual page), send a mail to [email protected]

iproute2                       12 Jan 2015           NAT action in tc(8)

Pages that refer to this page: tc-actions(8)